英文翻译一段话

1.根据标准A中的条款B提供的测试方法，对产品的鼻子进行拉力测试。
1 test methods according to the standard clause in A B, for tensile testing of products nose.
2.根据标准A中的条款B的要求，对产品的鼻子进行测试。
2 according to the standard A in terms of the B requirements, test the product's nose.
3.经过90N拉力测试后，产品的鼻子没有被拉脱出来。.
3 after the 90N after the tensile test, the product is not pulled out of the nose. .
4：
4.
标准中规定：It shall not be possible to insert the front part of a 1 12 mm diameter rod with a fully radiused end through any one penning in the seam or cover material by more than 6 mm.
Standards: It shall not be possible to insert the front part of a 112 mm diameter rod with a fully radiused end through any one penning in the seam or cover material by more than 6 mm.
意思是说
Mean
线缝或外罩上不应产生能使直径12mm、末端为圆弧状的塞规的前部插入深度超过6mm 的孔隙。
Seams or housing should not produce front can make the diameter of 12mm, at the end of the arc-shaped plug insertion depth more than 6mm of the pore.
经测试，线缝或外罩上没有产生能使直径12mm、末端为圆弧状的塞规的前部插入深度超过6mm 的孔隙。
after the test, the diameter of 12mm, the front end is a circular arc of the plug insertion depth more than 6mm of the pore has no seams or cover.

1. 根据标准A中的条款B提供的测试方法，对产品的鼻子进行拉力测试。

   To make a test of pulling force upon the nose / beezer of the products according to the testing method offered by Clause B in Standard A

2.根据标准A中的条款B的要求，对产品的鼻子进行测试。

Complying with the requirements of Clause B in Standard A , The nose / beezer of the products have been tested and examined

3.经过90N拉力测试后，产品的鼻子没有被拉脱出来。.

Undergoing the testing of Ninety Newton pulling force, The nose of product has not bee pull off / cast off

1 test methods according to the standard clause in A B, for tensile testing of products nose.

2 according to the standard A in terms of the B requirements, test the product's nose.

3 after the 90N after the tensile test, the product is not pulled out of the nose.

.4: Standard: It shall not be possible to insert the front part of a 112 mm diameter rod with a fully radiused end through any one penning in the seam or cover material by more than 6 mm

At mean seams or housing should not produce front can make the diameter of 12mm, at the end of the arc-shaped plug insertion depth more than 6mm of the pore. I want to change: after the test, the diameter of 12mm, the front end is a circular arc of the plug insertion depth more than 6mm of the pore has no seams or cover.

It was tested that it was impossible to insert the front part of a 1 12 mm diameter rod with a fully radiused end through any one penning in the seam or cover material by more than 6 mm.